How To Determine Ac Tonnage From Model Number Carrier Guide 2022. Kw x $kwh x h x d = $total cost. Basically all hvac manufacturers encode the size or tonnage of their systems into the model number.

Some manufacturer’s systems make this easier than others. Like most ac units, grandaire acs are easy to install. But, what do those model numbers mean?

Table of Contents

The Model And Serial Number As Well As Motor, Co.

Tonnage, air flow, kw, etc. For carrier furnace, the model number is listed on a rating plate inside the furnace. Basically all hvac manufacturers encode the size or tonnage of their systems into the model number.

Like Most Ac Units, Grandaire Acs Are Easy To Install.

To estimate your ac tonnage needs, multiply the number of square feet you’re cooling times 25. A 2.5 ton system would have 30,000 btu’s. This number can be elusive, as it is not always exactly divisible by 6.

(2) Hover Over Each Grouping To Reveal Pertinent Info For Each Part Of The Model Number.

Divide the number by 12 (which represents 12,000 btu/hr, or one ton of cooling capacity) to get your ac unit’s tonnage. Ac capacity (tonnage) = (insert area in sq ft) * 0.0016 tons/sq ft. However, their prices will differ depending on the tonnage size and model type.

Therefore, A Professional Calculation Might Show A Lower Requirement.

50,000 + 2,000 + 15,000 + 3,000 = 70,000 btus. Finally, you have the seer number. Here’s a rundown of the range you will encounter:

The Basic Formula Looks Like:

Subscribe to our youtube channel: Are located within the oval/round shaped buttons). After a few minutes of operation, water should trickle from the condensate drain of the indoor coil.