close
close

How To Reset Maintenance Light On Toyota Corolla 2014 References Guide 2022

How To Reset Maintenance Light On Toyota Corolla 2014 References Guide 2022. Turn the key back to “off.”. If this does not work, you can try and repeat the steps above.

from venturebeat.com

Go to the ⚙️ settings. While pressing the button to reset the trip, turn the key back to the “on” position. How do i turn off the maintenance light?

Push And Hold Down The Odo Button And Push The Power Button Twice With Your Foot Off The Brake.

How do i turn off the maintenance light? This should cause the light to flash, possibly beep, then turn off. Especially for the 2018 model, you can reset the maintenance light in the following way:

The Reset Can Be Performed By Following These Instructions:the “Maintenance Required” Light Should Be Off, And The Computer Will Now Begin Accumulating Miles From Zero.then Hold Odo/Trip Reset Button, Then Press The “ Engine Start Stop Button ” Twice Or Turn Ignition On Only, Don’t Release The Odo/Trip Button, Until The Resetting Oil Maintenance Data Or “ 000000 ” Is.

Keep holding the trip reset button until the miles section of the odometer flashes zero. While pressing the button to reset the trip, turn the key back to the “on” position. Finally, select yes to perform the maintenance data reset.

The “Maintenance Required” Notification Will Appear On The Toyota Corolla Once The Vehicle Has Travelled 4,500 Miles Since The Last Oil Change.once Maintenance Service Has Been Completed On The Vehicle, Use These Steps To Perform An Oil Reset.

This is how you turn off the maintenance light on a prius. Push and hold the trip meter reset button on the dashboard, then turn your key to the second position. 5 release the odometer reset button after the indicator displays 000000. the maintenance service light turns off.

Go To The ⚙️ Settings.

Turn the key back to “off.”. Turn on the ignition but don’t start the engine. While holding down the trip meter reset knob turn the ignition to run (one position before starting engine).

Step 2 Press The Odo/Trip Button To Display To Odo.

If this does not work, you can try and repeat the steps above. With the vehicle running you should set the odometer to trip a. 2 press the odometer reset button repeatedly until trip a is displayed.

Leave a Comment