close
close

How To Turn Maintenance Light Off Toyota Highlander Guide 2022

How To Turn Maintenance Light Off Toyota Highlander Guide 2022. In this section, i’ll show you how to reset the maintenance required light on toyota highlander with the trip button. If your vehicle has an ignition button, press the start/stop button two tomes without stepping on the brake pedal.

How To Turn Maintenance Light Off Toyota Highlander How from c1.reachhighrowing.org

The procedure for resetting your maintenance light on a toyota highlander will vary depending upon which model of toyota highlander you own. Press and hold odo/trip button and turn ignition to the “run” position. If you want to turn the light off then follow these steps.

Your Maintenance Light Pops On When You’re Due For A Visit To The Shop, Usually.

How do you reset the maintenance light on a toyota highlander? Continue to hold the odometer button for about 10 seconds. If the light is off when you start your car, the process is complete.

Quickly Push And Hold The Odometer Button On Your Dashboard, Then Turn Your Key To Position Two.

In this section, i’m going to show you how to reset the maintenance reminder light on toyota highlander. If your vehicle has an ignition button, press the start/stop button two tomes without stepping on the brake pedal. If the light is still on, repeat the process.

To Prevent Damage To The Vehicle, Wrap The Tip Of The Flathead Screwdriver With Tape, Etc.

When it stops, the light has been reset. Turn the ignition switch to the on position but do not crank the engine. How to turn maintenance light off toyota highlander how from www.apecwln.org.

How To Reset The Maintenance Light On A 2018 Toyota Highlander.

Turn the ignition on again. In the event that the maintenance reminder is not reset, you may need to manually reset the maintenance required light in your toyota highlander and we are here to help at st. Hold knob for at least 5 seconds until “000000” is displayed.

Then The Light Should Go Out.

Remove the securing 2 screws and light unit. Press and hold odo/trip button and turn ignition to the “run” position. If you have a toyota highlander with an automatic transmission, then you will need to follow this guide:

Leave a Comment