close
close

Maxxair Ii Vent Cover Installation Instructions

Maxxair Ii Vent Cover Installation Instructions. Rotate louver section upward and snap into top of the vent cover body. Read and save these instructions 1.

Maxx air vent installation instructions from albertborris.com

Ours had a timer that waited about 10 secs before it stopped trying to open. Maxxair ii™ aluminum bracket kit by maxxair®. Our vent covers, the original maxxair vent cover and the maxxair ii and are designed to fit over vents and allow you to travel with the vent open and keep the rain out.

Free Expert Support On All Maxxair Products.

Slide oval shaped tabs on louver section through the slots on the vent cover body. To reduce risk of fire, injury to persons or damage to property, use only in the manner intended by airxcel, inc. Place the maxxair over the roof vent with the louver area facing the rear of the vehicle.

Hinged Hardware Included For Easy Opening And Cleaning Without Tools.

Next, with the provided screws and a power drill, install the maxxair fan flange onto your camper’s roof. Move maxxair ii out of the way. Maxxair ii to install the hinged brackets.

Drill One 3/16” Hole At Center Of The Marked Slots.

Lay louver section behind opening of vent cover body with tabs up as shown in figure 1. Maxxair's line of high powered celing fans are easy to operate with convenient controls at the ceiling. Installation instructions for maxxair’s unimaxx universal vent lid replacement kit replaces damaged vent lids on elixir, hengs, jensen, ventline and other roof vent assemblies.

Have Your Helper Open The Roof Vent That You Are Working On;

Center the brackets front to back on the vent side wall. This product is made in the usa. Maxxair ii with the installed hinged brackets up to the side of your roof vent.

Ours Had A Timer That Waited About 10 Secs Before It Stopped Trying To Open.

The underside of the flange with the butyl tape should make contact with the van’s metal roof. Rotate louver section upward and snap into top of the vent cover body. Based on your roof vent location, choose which side of the.

Leave a Comment